Adjustable Aluminum Cross Tube (Up to 110”) parts-accessories This bearing features a 1"

This bearing features a 1" bore with a center to center mounting measurement of 4-1/8" or commonly rounded to 4" mount spacing

it is crucial you account for your steak pockets / top rail above or around where the tarp system arms will be pivoting

This Aluminum cross tube fits through the pocket on the end of your tarp and is used to pull the tarp out over your load

Complete a thorough check and installation of all wiring while all cables are unattached

Trailer and flatbed tarp systems requiring manual braking

Adjustable Aluminum Cross Tube (Up to 110”) parts-accessories This bearing features a 1"This 3 piece aluminum cross tube features an adjustable "no cut" design for easier installation and SIGNIFICANTLY lower shipping costs. Our 103" one piece cross tube must be measured and cut to an exact length, but this cross tube can be adjusted to fit any dump bed up to 110" wide. The assembly comes with one 47" center tube and two 45" telescoping tubes. Set screws tighten down on each end of the center tube to hold the telescoping tubes securely in